Model 560 Electrophoresis and Electron Beam Power Supply
- Soft start circuit
- Safety interlock
- Power interrupt trip
- Arc and short circuit protection
- Over voltage protection
Model 560 is a low-cost Electrophoresis and Electron Beam Power Supply designed for embedded systems. Its high voltage output is isolated from the AC line voltage and the case. A special circuit monitors leakage current to the case and trips a logic circuit for currents greater than 500 uA.
The unit is designed to withstand continuous short circuits without damage.
Manuals | 560 Manual
| Input voltage | 120/220 VAC, 50/60 Hz (Switch selectable) |
| Output voltage | Adjustable from 0 to 10 kV DC |
| Output current | 25 mA maximum |
| Adjustable output range | 100 to 5,000 V |
| Polarity | Positive or negative (factory selected) |
| Line and load regulation | Less than 5% |
| Output ripple | 0.1% at full load |
| Voltage programming | 0 to 5 V at 1 V per 2 kV of output (10 V optional) |
| Voltage monitor output | 0 to 5 V at 1 V per 2 kV of output (10 V optional |
| Current monitor output | 0 to 5 V at 1 V per 2 kV of output (10 V optional |
| Ground leakage monitor | 500 uA for <=1 s |
| Operating temperature range | 0 to 50 C |
| I/O connector | Alden Pulse Lok connector |
| Case ground | #10 threaded stud with nut |
| ISO ground | #8 threaded stud with nut |
| Enable pin | Yes (active when low) |
| Power input module | 3-wire line cord receptacle (fused) |
| LED power-on indicator | Yes |
| Temperature coefficient | 100 ppm/° C |
| Stability | Voltage 0.01% per hour, Current 0.05% |
| Efficiency | 80% |
| Approximate size | 130 x 180 x 280 mm |
| Model 560 Electrophoresis and Electron Beam Power Supply | Qty 1. $1,067 | Qty2-9. $970 |